Reference: HYD-001P
Brake lines – Hydraulic fittings The BERINGER brake line is stainless steel braided.
Reference: HYD-038
Brake lines The BERINGER brake line is stainless steel braided.
6" Wheel HL For Aircraft up to 2.5 tons (5,500 Lbs) References JI-XXX and JE-XXX are not sold, please refer to the 2nd and 3rd diagram of the product.
Banner
Master-cylinder features :
The master cylinders can be operated :
• with toes thanks to tabs on top of the rudder pedals
• with heels thanks to pedals bolted on the floor
• with hands thanks to either a lever on the stick (symmetrical braking) or a one or two lever assemblies mounted in the cockpit (respectively symmetrical and differential braking)
These master cylinders have been designed and tested to last 200,000 cycles (about two times the life of an aircraft…) with the same seals and piston !
They are machined from a high strength aluminum billet.
100% airtight, greased and anodized, they are completely protected against corrosion.
30% lighter than all other master cylinders on the market.
Friction is highly reduced for a better feeling and performance.
Seals available for either DOT4 or MIL fluid.
Caution : You must never mix the brake fluid : seals are different
There are 19 products.
Reference: CHP-002
Attachments/Extenders Attachments/Extenders for Brake Master Cylinders
Reference: HAB01/MM-001E
Hand Master Cylinders Allows to actuate the following calipers : For ø 7/8" (22mm) stick or 1" (25mm) stick
Reference: RV-001E
Red aluminum reservoirs To be mounted directly on the master cylinders. Vertical or horizontal mounting, 180° rotable. The reservoirs are 100% tight, without any risk of leak. Available for DOT4 or Minéral brake fluid. Perfect for Aerobatic use.
Reference: MP-004.1
Levers for master cylinders (hand) The MP-XXX brake master cylinders can be installed in the different levers described. They are heel actuated (levers on the floor). Using ball bearings for perfect control of the braking power.
Reference: MP-004.3
Levers for master cylinders (hand) The MP-XXX brake master cylinders can be installed in the different levers described. They are heel actuated (levers on the floor). Using ball bearings for perfect control of the braking power.
Reference: MP-004.6
Levers for master cylinders (hand) The MP-XXX brake master cylinders can be installed in the different levers described. They are heel actuated (levers on the floor). Using ball bearings for perfect control of the braking power.
Reference: AV-CUB-122
Levers for master cylinders (heel actuated) The MP-XXX brake master cylinders can be installed in the different levers described. They are heel actuated (levers on the floor). Using ball bearings for perfect control of the braking power.
Reference: HAC01/MM-002
Master Cylinder cable actuated : Allows to actuate following calipers : 1x 1P27 EA-009/9.1 - 2x 2P27 calipers EA-006/6.2 - 1x 2P32 EA-002
